12-13-2019 09:02 AM
I have a quick question.
The MGMT0 interfaces are being used for peer-keepalive between the switches.
The MGMT0 interfaces are connected via a crossover cable (think), not via an intermediate switch.
Can you advise if the best practice is to connect mgmt0 interfaces with a direct crossover cable or they should be connected to a switch.
Thanks,
Edouard.
Solved! Go to Solution.
12-13-2019 09:22 AM - edited 12-13-2019 09:30 AM
Hi,
They should be connected to a switch.
see figure-3 in this link for reference.
HTH
12-13-2019 09:22 AM - edited 12-13-2019 09:30 AM
Hi,
They should be connected to a switch.
see figure-3 in this link for reference.
HTH
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: