02-02-2015 05:31 PM - edited 03-07-2019 10:28 PM
I am configuring voice vlan on a Nexus5020 version 5.2(1)N1(8b).
I am getting the following error message:
nx5020-wc0(config)# interface Ethernet1/15
nx5020-wc0(config-if)# description Guarita
nx5020-wc0(config-if)# switchport access vlan 2
nx5020-wc0(config-if)# switchport voice vlan 112
ERROR: Configuration command not supported
nx5020-wc0# sh vlan brief
VLAN Name Status Ports
---- -------------------------------- --------- -------------------------------
1 default active Po75, Eth1/1, Eth1/2, Eth1/6
Eth1/7, Eth1/8, Eth1/12, Eth1/18
Eth1/19, Eth1/20, Eth1/21
2 administrativa active Po25, Po75, Eth1/1, Eth1/2
Eth1/4, Eth1/5, Eth1/9, Eth1/10
Eth1/15
3 sbm active Po75, Eth1/1, Eth1/2, Eth1/4
......
4 pesquisadores active Po25, Po75, Eth1/1, Eth1/2
Eth1/4, Eth1/5, Eth1/9, Eth1/10
110 servidores-internos active Po25, Po75, Eth1/1, Eth1/2
Eth1/9, Eth1/10
111 wifi-voip active Po75, Eth1/1, Eth1/2
112 telefones-voip active Po75, Eth1/1, Eth1/2, Eth1/4
Eth1/5
02-02-2015 06:26 PM
Hi Rosa,
The Nexus series switches do not support POE/Voice.
HTH
02-02-2015 06:56 PM
And why are there enabled voice commands on version 5.2(1)N1(8b). ?
02-02-2015 07:05 PM
Not sure. These switches are not POE switches. They are designed for data center and not campus.
HTH
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: