05-02-2013 05:31 AM - edited 03-07-2019 01:08 PM
hi all,
I bought a used 2610xm and install with NM-8A as my frame relay switch.
and my 1841 has wic-2t installed. but I don't know which cable I need for connecting both device via serial?
I checked datasheet, but still not sure which cable I need.
CAB-SS-V35MT V.35 DTE 10 feet (3 meters) Male
CAB-SS-V35FC V.35 DCE 10 feet (3 meters) Female
does that mean I need one cable mail connect to wic-2t, and another female cable connect to NM-8A, and then connect both cable together?
can someone help? I need to buy few for my ccnp lab. don't wanna buy wrong cable.
BRs,
Johnny
05-02-2013 05:44 AM
Hi,
You just need the DTE/DCE crossover cable.
They are pretty cheap these days.
have a look at this
http://www.amazon.com/Monoprice-3ft-DB60-Crossover-Cable/dp/B001TN0S8G
HTH
05-02-2013 08:58 AM
hi Reza,
but my wic-2t is a smart serial connector, do you which cable I should buy?
05-02-2013 09:27 AM
Ok, if your interface is smart serial interface, then you need smart serial crossover:
HTH
05-08-2013 02:27 PM
I found solution should be DB60 to SS cable. and it's very expansive. 15euro each. and I need to buy 11cable for my ccie lab.
thanks for your help
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: