cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
765
Views
0
Helpful
4
Replies

NM-8A and wic-2t , what cable I need?

chuang123
Level 1
Level 1

hi all,

I bought a used 2610xm and install with NM-8A as my frame relay switch.

and my 1841 has wic-2t installed. but I don't know which cable I need for connecting both device via serial?

I checked datasheet, but still not sure which cable I need.

CAB-SS-V35MT V.35 DTE 10 feet (3 meters) Male

CAB-SS-V35FC V.35 DCE 10 feet (3 meters) Female

does that mean I need one cable mail connect to wic-2t, and another female cable connect to NM-8A, and then connect both cable together?

can someone help? I need to buy few for my ccnp lab.  don't wanna buy wrong cable.

BRs,

Johnny

4 Replies 4

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

You just need the DTE/DCE crossover cable.

They are pretty cheap these days.

have a look at this

http://www.amazon.com/Monoprice-3ft-DB60-Crossover-Cable/dp/B001TN0S8G

HTH

hi Reza,

but my wic-2t is a smart serial connector, do you which cable I should buy?

Ok, if your interface is smart serial interface, then you need smart serial crossover:

http://www.cablesandkits.com/cisco-smart-serial-crossover-cable-6-cabss2626x6-p-872.html?gclid=CKP01u3q97YCFYOK4AodHXwAhg

HTH

I found solution should be DB60 to SS cable. and it's very expansive. 15euro each. and I need to buy 11cable for my ccie lab.

thanks for your help

Review Cisco Networking for a $25 gift card