02-17-2020 10:31 AM
Hello,
I accidentally pushed the 'no exec' command on a couple switches remotely and unfortunately it saved the config too! Obviously I do not had access to the switches now so I was wondering if anyone knew of a way to fix this without wiping the switch?
Thanks.
02-17-2020 11:01 AM
Hi,
Not sure if there is way to recover from that without wiping the config since you added it to both vty lines and con 0 .
HTH
02-17-2020 11:04 AM
Not that I am aware of any other procedure, you can get into recovery mode and change the config and load the config from the console.
02-18-2020 05:24 AM
do you have snmp write strings configured on these? If you do, you can push a config file and restore your vtys
02-18-2020 01:30 PM
yes good point using snmp.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide