cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
477
Views
15
Helpful
4
Replies
Highlighted
Beginner

No Exec added on both line con 0 and line vty 0 15

Hello,

 

I accidentally pushed the 'no exec' command on a couple switches remotely and unfortunately it saved the config too! Obviously I do not had access to the switches now so I was wondering if anyone knew of a way to fix this without wiping the switch? 

 

Thanks. 

 

4 REPLIES 4
Highlighted
Hall of Fame Expert

Hi,

Not sure if there is way to recover from that without wiping the config since you added it to both vty lines and con 0 .

HTH

Highlighted
VIP Mentor

Not that I am aware of any other procedure, you can get into recovery mode and change the config and load the config from the console.

 

BB
*** Rate All Helpful Responses ***
Highlighted
Enthusiast

do you have snmp write strings configured on these? If you do, you can push a config file and restore your vtys

Highlighted

yes good point using snmp.

 

BB
*** Rate All Helpful Responses ***
Content for Community-Ad