Not able to define qos type queuing on Nexus 1000V

[Alberto Falconi]

Hello does someone knows why I get this error on my Nexus 1000V version 4.2(1)SV2(1.1a) ?

switch-01(config)# class-map type queuing pippo

ERROR: Command (id: 2) not supported

should I enabe queuing somewhere ?

Thank you in advance ...

[acampbell]

Alberto,

Canyou try your command again but like these:-

class-map type queuing match-any pippo

or

class-map type queuing match-all pippo

Regards,
Alex.
Please rate useful posts.

[Alberto Falconi]

As before ... same problem ..

switch-01(config)# class-map type queuing match-any pippo

ERROR: Command (id: 2) not supported

switch-01(config)# class-map type queuing match-a

match-all   match-any

switch-01(config)# class-map type queuing match-all pippo

ERROR: Command (id: 2) not supported

switch-01(config)#

[acampbell]

Alberto,

According to the QOS config guide for your version :-

http://www.cisco.com/en/US/docs/switches/datacenter/nexus1000/sw/4_2_1_s_v_2_1_1/qos/configuration/guide/b_Quality_of_Service_Configuration_Guide_Release_4_2_1SV2_1_1_chapter_0110.html#concept_1C3B684C62BA46498A2D335F88DE3236

The olny item I can see that may be stopping the command is :-

Queuing is only supported on ESX or ESXi 4.1.0 or later hosts.

If you are meeting the criteria I think you should raise a TAC -- I could not find any bug for this

Regards,
Alex.
Please rate useful posts.

[Alberto Falconi]

Strange because ESXi is VMware ESXi 5.1.0 Releasebuild-1117900 (3.1)

nobody else got this error ?