cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
287
Views
0
Helpful
2
Replies

Opening ports to be used on 4506 ...

sanjaynadarajah
Level 1
Level 1

Hi,

I have a camera system that needs to use ports 5001 and 5002 on a 4506 system ... How do I make these ports available to the camera system ?

Surprisingly it works with no issues on the 2950 switch.

[1] Doees anyone know how do I make this port available 5001 and 5002 for the camera on the 4506s (inbound/outbound UDP ?

Thank you,

- Sanjay -

2 Replies 2

Amit Singh
Cisco Employee
Cisco Employee

Snajay,

You cannot open the ports as such on the 4506. let us know the topology/configuration done on 4506.

How was the config done on 2950. Were these used in the same vlan on 2950.

How is the cameras configured on 4506. Are they in the same vlan or different vlan.

-amit singh

glen.grant
VIP Alumni
VIP Alumni

By default all ports are allowed unless someone has put an acl or other restrictions on the port , sounds like a misconfiguration of the switch .

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco