04-10-2019 06:59 AM
Hi,
I am using PT 7.2.1 and am trying to emulate our 4500 core using 2 3650's. I understand I cannot use VRRP and the likes but was hoping I could use HSRP ?.
I have the 2 3650's trunked together using 2 interfaces and a port channel however HSRP does not seem to work, should it. ?
04-10-2019 08:28 AM
04-10-2019 10:29 AM
Hello,
on a side note, I don't get an option for HSRP for IPv4 on a port channel interface on the 3650, so it doesn't seem to be supported on that device:
Switch#conf t
Switch(config)#ip routing
Switch(config)#interface port-channel 1
Switch(config-if)#standby 1 ?
ipv6 Enable HSRP IPv6
04-10-2019 11:45 AM
Shut down PT and start back up and launch scenario and it works !!
Core_2#sh standby
Vlan41 - Group 41
State is Active
6 state changes, last state change 00:00:28
Virtual IP address is 10.50.41.1
Active virtual MAC address is 0000.0C07.AC29
Local virtual MAC address is 0000.0C07.AC29 (v1 default)
Hello time 3 sec, hold time 10 sec
Next hello sent in 0.678 secs
Preemption enabled
Active router is local
Standby router is 10.50.41.2
Priority 115 (configured 115)
Group name is hsrp-Vl4-41 (default)
Vlan42 - Group 42
State is Active
4 state changes, last state change 00:00:18
Virtual IP address is 10.50.42.1
Active virtual MAC address is 0000.0C07.AC2A
Local virtual MAC address is 0000.0C07.AC2A (v1 default)
Hello time 3 sec, hold time 10 sec
Next hello sent in 1.92 secs
Preemption enabled
Active router is local
Standby router is 10.50.42.2
Priority 115 (configured 115)
Group name is hsrp-Vl4-42 (default)
04-10-2019 12:16 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide