Hi,
I am trying to add 802.1x config into my existing switches. May I knw if messages below will posses any risk to my existing switches config & operation?
##parameter-map type webauth activate-802.
This operation will permanently convert all relevant authentication commands to their CPL control-policy equivalents. As this conversion is irreversible and will disable the conversion CLI 'authentication display [legacy|new-style]', you are strongly advised to back up your current configuration before proceeding.
Do you wish to continue? [yes]:
yes
#no parameter-map type webauth activate-802.1x
Will this command change any of my existing switch config or posses any risk to existing config?