All my TwinGig converter modules have a part number " CVR-X2-SFP V02" on them but trying to order a new one and the vendor says the V02 doesn't exist. And nothing shows up on the site dealing with that part number. Does the V02 matter or not?
my TwinGig converter modules have a part number " CVR-X2-SFP V02" on
them but trying to order a new one and the vendor says the V02 doesn't
exist. And nothing shows up on the site dealing with that part number.
Does the V02 matter or not?
Check out the below link on TwinGig converter modules with part number details
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...