cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
461
Views
0
Helpful
1
Replies
aducey01
Beginner

password recovery on a 3600 router

I'm using the ctrl-break sequence in hyperterminal during the the initial boot, and it's hanging....any suggestions?

thanks,

A J

1 REPLY 1
Sebastian Helmer
Contributor

Did you try it with putty too?

And what I found on the password recovery site from Cisco is that, maybe this is important..I have no experience with that series..

mportant Notes:

  • In order to simulate this step on a Cisco 6400, pull out and then plug in the Node Route Processor (NRP) or Node Switch Processor (NSP) card.
  • In order to simulate this step on a Cisco 6x00 with NI-2, pull out and then plug in the NI-2 card.