PBR is not working

onlinerecharge · ‎03-15-2013

Dear All,

I have created a PBR in 3650 switch to route traffic from a specific IP address to a specific next hop or IP address(Router)

ROM: Bootstrap program is C3560 boot loader

BOOTLDR: C3560 Boot Loader (C3560-HBOOT-M) Version 12.2(44)SE5, RELEASE SOFTWARE (fc1)

SW1 uptime is 6 weeks, 2 days, 16 minutes

System returned to ROM by power-on

System image file is "flash:/c3560-ipservicesk9-mz.150-1.SE2.bin"

access-list 101 permit ip host 192.168.170.92 10.10.10.0 0.0.0.255

route-map MPLS permit 101

match ip address 101

set ip next-hop 192.168.170.4

The next hop router is connected to this switch directly and member of vlan 170,

I am getting the following error

*Apr 13 23:48:25.104: %PLATFORM_PBR-4-SDM_MISMATCH: PBR requires sdm template routing

I also enable "

sdm prefer routing" but still not working.

any sugestion please

jj27 · ‎03-15-2013

Did you place the route map on the ingress interface (I assume L3 SVI for 192.168.170.0 network) for the traffic?

interface vlanXX

ip policy route-map MPLS

onlinerecharge · ‎03-15-2013

yes also did this already but still not working.

jj27 · ‎03-15-2013

Did you reboot the switch after you enabled the sdm prefer routing?

It is required when you issue that command.

mikegrous · ‎03-15-2013

sdm prefer takes effect upon reboot.

onlinerecharge · ‎03-15-2013

no......ok i will reboot the switch and let you know....can you tell me ,,it there any issue that can be create after enabling sdm frefer routing

mikegrous · ‎03-15-2013

it changes the allocation of TCAM memory. I imagine you should be fine. Ive never had an issue when changing it.