12-03-2018 12:01 AM - edited 03-08-2019 04:43 PM
Hello!
I would like to know how to verify PBR running on Catalyst 3650 switch is working. (The version is 16.6.4)
I tried some commands below but they didn't clarify whether or not it was operating properly.
- show ip access-list
* The match counter was not incremented.
- show route-map
* The match counter was not incremented.
- debug ip policy
* No output was displayed.
Because Catalyst 3650 processes PBR on the hardware, do these commands not show anything?
Thank you in advance.
Best Regards,
12-03-2018 12:43 AM
Hello,
post the config of your 3650....
12-03-2018 06:42 AM
Seeing the config will be very helpful. In particular we will be looking to see if the route map for PBR is applied on the interface where the traffic arrives at the switch.
HTH
Rick
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide