cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
257
Views
0
Helpful
1
Replies

pc can't recongnized network is ok after connecting back from another pc

jerry zhung
Beginner
Beginner
Recently i has very strange problem, a pc (only the user) can not access network and display can't recognized network, but when connected to another pc and then back to itself, it is  normal again. it has happened third time regulatly
 
the following is related refer :
 
1, switch is 2960g
2, no crc error
3, only user,one account use the pc
 
switch interface config
----------------------------------------

switchport access vlan

switchport mode access

authentication order mab

authentication port-control auto

mab

dot1x pae authenticator

-------------------------------------

switch log :

%LINEPROTO-5-UPDOWN: Line protocol on Interface, changed state to down

%LINK-3-UPDOWN: Interface, changed state to down

 

 

 

 
1 Accepted Solution

Accepted Solutions

Marvin Rhoads
Hall of Fame
Hall of Fame

Since you're using MAB (MAC Authentication Bypass) you should be checking your RADIUS server (ACS or ISE probably) for the settings particular to the port.

MAB is a means of ensuring only a specific device is allowed to connect to a given port or switch. 

View solution in original post

1 Reply 1

Marvin Rhoads
Hall of Fame
Hall of Fame

Since you're using MAB (MAC Authentication Bypass) you should be checking your RADIUS server (ACS or ISE probably) for the settings particular to the port.

MAB is a means of ensuring only a specific device is allowed to connect to a given port or switch. 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: