cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
281
Views
0
Helpful
0
Replies
Highlighted
Beginner

per port per vlan rate-limiting - "match vlan" error on cisco 7600 + SUP720-3B

Hi,

I have a question about a per port per vlan rate-limiting on a

cisco 7600

eth#show module
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 24 CEF720 24 port 1000mb SFP WS-X6724-SFP SAL1072CG0F
5 2 Supervisor Engine 720 (Active) WS-SUP720-3B SAL1017M4XQ

Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
1 0019.7606.f714 to 0019.7606.f72b 2.5 12.2(14r)S5 12.2(33)SRD3 Ok
5 0015.b62f.d2e4 to 0015.b62f.d2e7 5.2 8.5(2) 12.2(33)SRD3 Ok

Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
1 Centralized Forwarding Card WS-F6700-CFC SAL1106DHP0 2.1 Ok
5 Policy Feature Card 3 WS-F6K-PFC3B SAL1019M3J6 2.3 Ok
5 MSFC3 Daughterboard WS-SUP720 SAL1017MAEW 2.5 Ok

Mod Online Diag Status
---- -------------------
1 Pass
5 Pass

This is an example of  classification

class-map match-any 427MIETH01
match vlan 1000-1001
!
policy-map P427
class 427MIETH01
bandwidth 10000


interface g1/1

switchport

switchport trunk encapsulation dot1q

switchport mode trunk service-policy input P427
when I attach the policy-map P427 on a trunk interface I receive this error:
"Match vlan is not supported for this interface" ?

Thanks
Roberto
Everyone's tags (6)
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards