cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
198
Views
1
Helpful
1
Replies

policy-map configuration problem in Catalyst 9200 IOS XE 17.09.04a

bensonlei
Level 1
Level 1

Hi, guys,

"Total output drops" are found in some switchports of my Cat9200L stack ( two switches stack ), that uses IOS XE Version 17.09.04a; and the "qos queue-softmax-multiplier 1200" can not solved the problem of all switchports, so I tried to configure policy-map for some switchports, however, the policy-map configuration can not be completed as the bottom;

My problem is the following problem ( class map class1 not configured):

Cat9200L#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Cat9200L(config)#policy-map test2
Cat9200L(config-pmap)#class class1
class map class1 not configured
Cat9200L(config-pmap)#

 

 

The policy-map example ( from cisco document

9500H(config)#policy-map test2
9500H(config-pmap)# class class1
9500H(config-pmap-c)# priority level 1
9500H(config-pmap-c)# queue-buffers ratio 50
9500H(config-pmap-c)# class class-default
9500H(config-pmap-c)# bandwidth remaining percent 100
9500H(config-pmap-c)# queue-buffers ratio 50

 

 

1 Accepted Solution
1 Reply 1
Review Cisco Networking for a $25 gift card