cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
152
Views
0
Helpful
1
Replies
Highlighted
Beginner

Policy map for a Cisco AP on a 3750-X switch port

Can anyone advise on a good default policy-map for a Cisco AP on a 3750-X switchport?  I am particularly concerned about ensuring that CAPWAP traffic is not dropped on a pretty busy switch.  Also any other advice about the switchport configuration?  I did configure "mls qos trust dscp" on both the AP interfaces and the trunk uplink but I still have issues where an AP will every so often just lose its connection to the WLC.

Thanks

Everyone's tags (3)
1 REPLY 1
VIP Mentor

Re: Policy map for a Cisco AP on a 3750-X switch port

Hello,

 

CAPWAP uses UDP ports 5246 and 5247, you could try the service policy below. Not sure if that solves your problem though...

 

access-list 101 permit udp any any eq 5246
access-list 101 permit udp any any eq 5247
!
class-map CAPWAP_CLASS
match access-group 101
!
policy-map CAPWAP_POLICY
class CAPWAP_CLASS
set dscp cs7
!
interface GigabitEthernet0/7
service-policy input CAPWAP_POLICY

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards