cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

831
Views
10
Helpful
9
Replies
Highlighted
Beginner

Port 5000 is being used by system

Cisco 4331 Router

ip nat inside source static tcp 192.168.200.45 5000 interface GigabitEthernet0/0/0 5000

%Port 5000 is being used by system

 

any guesses?

 

 

Everyone's tags (2)
9 REPLIES 9
Highlighted
VIP Mentor

Re: Port 5000 is being used by system

what is the version of code running, i have seen someone reported before has some bug same kind?

 

BB
*** Rate All Helpful Responses ***
Highlighted
Beginner

Re: Port 5000 is being used by system

Maybe it is possible

Highlighted
VIP Mentor

Re: Port 5000 is being used by system

there is bug reported and see the workaround posted other post.

 

BB
*** Rate All Helpful Responses ***
Highlighted
Beginner

Re: Port 5000 is being used by system

This is a bug. Apparently you need to create overload rule first, then add static nat rules.

Conditions:
ISR4351 running version 15.4(3)S1
NAT Overload had been configured before the Port Forwarding attempt.
Workaround:
Remove all nat statments and configure static nat before nat overload.

- remove all NAT statements

- save

- reboot

- drop in static NAT statements

- put in PAT/Overload NAT

Highlighted
Beginner

Re: Port 5000 is being used by system

Already tried, don't works

Highlighted
VIP Mentor

Re: Port 5000 is being used by system

check this thread may help you :

 

https://community.cisco.com/t5/switching/quot-nat-port-lt-gt-is-being-used-by-system-quot-on-cisco/td-p/2890534

 

still, having an issue worth opening the TAC case to assist better.

 

BB
*** Rate All Helpful Responses ***
Highlighted
Beginner

Re: Port 5000 is being used by system

:(

That was the only reference to the issue that I could find :(

Highlighted
VIP Mentor

Re: Port 5000 is being used by system

yes, i am afraid, i can not simulate your issue, do not have ISR in hand now..raise TAC to get a quick fix.

 

BB
*** Rate All Helpful Responses ***
Highlighted
VIP Mentor

Re: Port 5000 is being used by system

Hello,

 

I think you deleted your previous post, not sure if you have seen the last suggestion.

 

Check if your IOS supports the command below:

 

ip nat settings interface-overload block port tcp 5000

 

That would free the port to be used for static NAT. I do think you need a 16.x XE release for the command to be available, not sure about that...

CreatePlease to create content
Content for Community-Ad