I have been installing Cisco wireless for some years and recently started to get involved with LAN related switches so a steep learning curve and I have just installed a wired and wireless network in a warehouse that had no LAN so to connect it back to the main LAN I have used a root and non-root wireless bridge. The new LAN has a new SFE2000 switch with access points connected (plus a couple of repeaters) to it along with 2 wireless non-root access points (for resilience) that in turn conect to an existing SB Pro ESW520 switch on the main site LAN via 2 Root access points.
I'm getting started and have run into a problem already! The diagram below outlines the topology and essentially i get the following error generated by the small business pro ESW520 switch when the wireless bridge forms:
Warning %2SWPORT-W-LOCKPORTACTIVE: A packet with source MAC 50:57:a8:ea:4c:02 tried to access through port e8 which is locked.
The MAC address listed belongs to 192.168.6.232 on of the Non-Root access points.
The ESW520 switch is also showing the Root access point connected to port e8 as a "root" which i believe should not be the case?
I suspect the design is fundamentally flawed so would appreciate any pointers such as whether the non-root and or Root access points should be connected to the "G" Uplink ports or whether there is a configuration mismatch between the 2 switches somewhere?
Hi, I want to redistribute OMP routes to BGP, i have the doubt if all of the OMP prefixes located in the local vEdge will be redistributed to BGP or just the connected+static networks located in the vEdge. Also how can i restrict some OMP prefix...
Let's say we have two routers configured as RP candidates for auto-RP: R1 - "advertising" its loopback0 interface IP address 184.108.40.206 as the RP for these groups:220.127.116.11/3218.104.22.168/3222.214.171.124/24126.96.36.199/16 R2 - "advertising" its loopback0 int...
hi,i just performed an IOS upgrade and got a report that admin can't create L2 VLANs.i noticed the 'vtp primary force' and 'vtp primary mst' was applied to one of the core switch and perhaps got lost after the upgrade.how to keep the VTP primary persisten...
Meet the Authors Event - How to Troubleshoot Network Problems with Vinit Jain
(Live event – Wednesday, February 12th, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 7:00 p.m. Paris)
This event had place on Wednesday 12th, February 2020 at 10hrs PDT ...