01-22-2013 06:57 AM - edited 03-07-2019 11:14 AM
Hi All,
I am having 2 switch, in which i planned to use port channel. My question is
1. If I configure both the switches with channel group, do I have to use same channel number. ( I planned to use LACP )
2. If it is necessary to configure port channel on both the switches or configuring on one seitch is enough. If I am supposed to configure on both the switches, do I have to use same channel number.
01-22-2013 06:59 AM
Hello Sabari,
1) the channel group number can be different on the two switches
2) both switches have to be configured for the same bundling protocol LACP (in your case)
missing to configure one switch would lead to a non working bundle.
Use of LACP is highly recommended instead of unconditional bundling.
For LACP at least one side has to be configured to be in active state in order to start bundle negotiation,. usually both switches are configured with active mode.
Hope to help
Giuseppe
01-22-2013 08:09 AM
As Giuseppe said the port channels do not have to match but from a standard troubleshooting angle, I find it easier to make them the same and use port descriptions so everything lines up. Makes things easier if you have to troubleshoot in the long run.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: