Port channel bandwidth on Nexus 9K

[war202994]

Good Morning 

I had a quick question and I am probably looking in the wrong place but wasn't able to find any docs on this

but I have 2 10 gig interfaces that I combined into a port channel I would assume that the speed shown would be

20Gbps but when I look at them the speed is 10Gbps.  Is this by design or am I configuring something wrong?

This is on a Nexus 9k C93108TC-EX chassis

Po2 Xconnect  connected trunk full 10G --

interface port-channel2
description Xconnect
switchport
switchport mode trunk

Eth1/45 Xconnect connected trunk full 10G 10g
Eth1/46  Xconnect connected trunk full 10G 10g

interface Ethernet1/45
description Xconnect
switchport
switchport mode trunk
logging event port link-status
channel-group 2
no shutdown

interface Ethernet1/46
description Xconnect
switchport
switchport mode trunk
logging event port link-status
channel-group 2
no shutdown

[Reza Sharifi]

Hi,

Try "sh int po2" 

you should see something like this:

BW 20000000 Kbit/sec, DLY 10 usec

HTH

[war202994]

Hi Reza

Yes I do see it at 20Gbps when I do as you mention sh int po2 , question is why when I do "sh inter statu" PO2 says 10gig instead of 

20 would you happen to know or lead me to documentation as to why this is?

port-channel2 is up
admin state is up,
Hardware: Port-Channel, address: 0027.e36a.c4de (bia 0027.e36a.c4de)
Description: X to sf6landswa144ha1
MTU 1500 bytes, BW 20000000 Kbit, DLY 10 usec

Thank you sir!!

[Reza Sharifi · Accepted solution]

Hi,

"sh inter statu" will only show you the speed of the physical interface which is 10Gig and not the aggregate bandwidth.

That is the case with different platforms.

HTH

[war202994]

oh ok makes sense thank you sir!!

[Reza Sharifi]

Anytime. Glad to help!