cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
844
Views
0
Helpful
2
Replies

Port-channel between 3750 and 2960

remarkit
Level 1
Level 1

Hi,

 

I have plugged 2 UTP 1Gb cable on 2 ports of a 3750 switch and 2 ports of a 2960 switch.

 

I am trying to trunk the 2 switches with a port-channel, but something seems off in my configs since the port-channel reports a speed of 1000Mb/s when I wass expecting 2000Mb/s

 

Config on Switch1

interface Port-channel1
switchport trunk encapsulation dot1q
switchport mode trunk


interface GigabitEthernet1/0/11
description -empty-
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 1 mode on
!
interface GigabitEthernet1/0/12
description Trunk port to 10.1.255.100 port 24
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 1 mode on
!

 

Some more info

Switch1#show interfaces port-channel 1
Port-channel1 is up, line protocol is up (connected)
Hardware is EtherChannel, address is d4a0.2ab7.b48c (bia d4a0.2ab7.b48c)
MTU 1500 bytes, BW 2000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 0/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is auto, media type is unknown
input flow-control is off, output flow-control is unsupported
Members in this channel: Gi1/0/11 Gi1/0/12
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
12227738 packets input, 2355872064 bytes, 0 no buffer
Received 115654 broadcasts (114816 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 114816 multicast, 0 pause input
0 input packets with dribble condition detected
30714069 packets output, 25032340084 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out

 

 

Switch1#show etherchannel
Channel-group listing:
----------------------

Group: 1
----------
Group state = L2
Ports: 2 Maxports = 8
Port-channels: 1 Max Port-channels = 1
Protocol: -
Minimum Links: 0

 

Config on Switch2


interface Port-channel1

interface GigabitEthernet1/0/23
channel-group 1 mode on
!
interface GigabitEthernet1/0/24
description Trunk Port to Stack Master's port 12
channel-group 1 mode on
!

Some more info:

 

Switch2#show int port-channel 1
Port-channel1 is up, line protocol is up (connected)
Hardware is EtherChannel, address is 00cc.fc21.7e98 (bia 00cc.fc21.7e98)
MTU 1500 bytes, BW 2000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, link type is auto, media type is unknown
input flow-control is off, output flow-control is unsupported
Members in this channel: Gi1/0/23 Gi1/0/24
ARP type: ARPA, ARP Timeout 04:00:00
Last input 19:36:42, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 58000 bits/sec, 106 packets/sec
5 minute output rate 4000 bits/sec, 5 packets/sec
30728351 packets input, 25033314906 bytes, 0 no buffer
Received 7136969 broadcasts (626201 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 626201 multicast, 0 pause input
0 input packets with dribble condition detected
12226992 packets output, 2355786810 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out

 

 

Switch2#show etherchannel
Channel-group listing:
----------------------

Group: 1
----------
Group state = L2
Ports: 2 Maxports = 8
Port-channels: 1 Max Port-channels = 1
Protocol: -
Minimum Links: 0

 

 

Can someone help me get it right?

 

Thank you

1 Accepted Solution

Accepted Solutions

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

The numbers are correct. Look at the bandwidth, which is 2Gig.

BW 2000000 Kbit,

 

HTH

View solution in original post

2 Replies 2

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

The numbers are correct. Look at the bandwidth, which is 2Gig.

BW 2000000 Kbit,

 

HTH

Joseph W. Doherty
Hall of Fame
Hall of Fame
BTW, don't forget, any single flow will still be limited to 1 gig.
Review Cisco Networking for a $25 gift card