Hi,
I am trying to configure some 3020 blade center interconnects for an HP blade center for the first time.
I have placed 3 interfaces in a port channel on the interconnect and upstream switch. However the port-channel is down and down on both devices. The respective interfaces are up and up, except for the Gi0/1 interface on the interconnect which is set to track the state of the relevant port channel.
If I remove this link state tracking, the interface relating to the blade comes up and I can ping the interconnect from the blade and vice versa, but cannot ping from the interconnect to the upstream switch.
The interconnect and switch configs are attached.
