04-26-2007 04:38 AM - edited 03-05-2019 03:42 PM
Hello;
First time using these forums; How can i check when a switching port was in last use? What command shuld i be using?
Thank you.
04-26-2007 04:50 AM
Hi there,
Try "show logging", but note for the logging buffer if you are locally logging.
HTH, please rate if it does help,
Mohammed Mahmoud.
04-26-2007 05:30 AM
I'd agree with show log.
You could also try sh int fax (see line 7 "Last input")
Same for serial links also.
FastEthernet0/x is down, line protocol is down
Hardware is Fast Ethernet, address is 0030.1942.d458 (bia 0030.1942.d458)
MTU 1500 bytes, BW 0 Kbit, DLY 100 usec, rely 255/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive not set
Duplex setting unknown, Unknown Speed, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
HTH
04-26-2007 05:44 AM
Hi,
Forgot to say that if it was a subinterface, you'll need to add the following command
Switch(config-if)#logging event subif-link-status
HTH,
Mohammed Mahmoud.
04-26-2007 07:31 AM
Thank you very much...all of you...
Great Help...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide