port switch is not stable

[Dhikra Marghli]

problem port is not stable

 i have a switch 2960-X linked with WLC 1815i with inter gi/0/15 

probleme : port switch : green ( 60 seconde ) then Off ==> i would port switch green stable  that allow WLC is green ?

what comand used to trouble switch 2960-X ??????? 

[Dhikra Marghli]

 i have a switch 2960-X linked with WLC 1815i with inter gi/0/15 

probleme : port switch : green ( 60 seconde ) then Off ==> i would port switch green stable  that allow WLC is green ?

what comand used to trouble switch 2960-X ??????? 

[marce1000]

 - Configure the port with logging event link-status (too);  periodically check the switch-logs by issuing show logging. On the long run it is better to configure the switch and the wlc to forward events to a syslog sever. To  be more comfortable when analyzing events.

M.

[Dhikra Marghli]

i send you a file to show output

pease help me what i can do for this problem that i can allow PORT is led green stable and WLC is green stable

i wait a solution 

thanks in advance 

[Dhikra Marghli]

i send you a file to show output 

[Mark Malone]

Hi
can you post below please see whats up with the interface if there any errors

show interface e GigabitEthernet1/0/15
sh run int g1/0/15

[Dhikra Marghli · Accepted solution]

I send you a file that contain all show output

i hope please to resolve port switch  that to be green stable 

[Dhikra Marghli]

i send a file  that allow to show output

[Dhikra Marghli]

i send a file  that allow to show output

[Mark Malone]

that interface is clean no issue could be on the far end connection

post thos command from the switch
show spanning-tree detail | inc ieee|occurr|from|is exec

Please post the WLC interface switch is connected too , show interface x/x

[Dhikra Marghli]

i send you a file 

so what is solution for port switch !!

[Dhikra Marghli]

i send you a file

SO what is probleme and solution !!

i wait for this team to resolve this port 

[Georg Pauwen]

Hello,

try and configure the port on your switch as a trunk:

interface GigabitEthernet1/0/15

switchport mode trunk

[Dhikra Marghli]

no resulat , same problem

so what i can used as command or as show ????,,

[Georg Pauwen]

What is the management VLAN on the AP ? Make sure that is is set to the native VLAN when you configure a trunk on the switch:

Here is an example:

Interface GigabitEthernet1/0/15
switchport trunk native vlan 2
switchport trunk allowed vlan 2,10,20,30
switchport mode trunk

[Dhikra Marghli]

the problem is remain i try all possiblite  but port switch green after off then green