PortChannel config isn't writing to all etherchannel interfaces

[hvctorgamez]

Good day and thank you for reading!

I have a small question, I created port channels, written the configurations, and assigned them to their specific interfaces. For some reason it's not passing through to the other interfaces. Everything seems to have worked as only half of the configurations didn't get their config.

Maybe one of you experts can enlighten this rookie!

Attached are the images and any help/information would be greatly appreciated-

Each portchannel config written out and assigned to their specific interfaces-

Channel-Group was made active on each interface-

But it didn't pass on to every interface-

Thank you!

[MHM Cisco World]

I think you need first to 
switchport mode trunk 
then 
switchport trunk allowed vlan ........

to check 
show interface x switchport 

check if the interface is Operational  trunk not access