cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
667
Views
0
Helpful
3
Replies
Highlighted
Beginner

Private-VLAN Question 3750 --- 2950 -- host

the topology is:

3750 -- 2950 -- host(20 stations)

3750 support Private-vlan

2950 not support

3750's f0/37 connected to 2950's f0/29

f0/37 configured as isolate port

and don't config the 2950.

if the 20 hosts can communicate with each other on the second layer.

and why?

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Beginner

Re: Private-VLAN Question 3750 --- 2950 -- host

Hi,

If you set private Vlans on 3750 and 2950 does not support it, then hosts in the same vlan will be able to communicate with each other throught 2950 switch (layer 2 traffic).

If you want to create a fully private vlan topology then you need to configure it on both 3750 and 2950 switch (upgreat IOS to one that supports pvlan).

Hope that expalains why, if yes, please rate it.

Regards:

Michal

View solution in original post

3 REPLIES 3
Highlighted
Beginner

Re: Private-VLAN Question 3750 --- 2950 -- host

Hi,

If you set private Vlans on 3750 and 2950 does not support it, then hosts in the same vlan will be able to communicate with each other throught 2950 switch (layer 2 traffic).

If you want to create a fully private vlan topology then you need to configure it on both 3750 and 2950 switch (upgreat IOS to one that supports pvlan).

Hope that expalains why, if yes, please rate it.

Regards:

Michal

View solution in original post

Highlighted
Beginner

Re: Private-VLAN Question 3750 --- 2950 -- host

then i can't constrain ARP virus or hack attack using private-vlan.

and DAI also can't give a proper solution if i don't use 3750 throughout my LAN.

Highlighted
Beginner

Re: Private-VLAN Question 3750 --- 2950 -- host

Hi, Michal!

Can you tell me, how to configure 2950 and 3750 to work together.

2950 - use protected port?

and how to configure 3750 to use protected port from 2950?

Dima.

CreatePlease to create content
Content for Community-Ad