problem enable ssh switch C4500X16FP

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-22-2018 08:01 AM - edited 03-08-2019 03:06 PM
Hi Guys
I need help on switch since it does not allow to configure ssh
this is the information
Versión de software C4500X16FP
Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSAL-M), Version 03.09.00.E RELEASE SOFTWARE (fc1)
ROM: 15.0(1r)SG12
regards
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-22-2018 08:18 AM
did you configure your hostname, domain-name and generated crypto key for SSH and then enaled SSH?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-22-2018 08:31 AM
What response do you get it you do
crypto ?
Does the file name for the image include "k9"? K9 indicates that the image does have support for crypto and this is a requirement for SSH. Perhaps you could post the output of show version which would allow us to see the file name.
HTH
Rick
Rick
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-22-2018 09:10 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-22-2018 09:41 AM
Hi,
Your software (cat4500e-UNIVERSAL-M) does not allow you to configure SSH, for the same reason Rick described.
HTH,
Meheretab
Meheretab
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-22-2018 04:46 PM
