Public IP addresses, NAT issue with Cisco 800 Series
Hello community, I'm writting to have orientation regarding a NAT issue and the IP addresses our company's ISP provider gave us. We have a block of 6 IP's lets say from 190.xx.xx.112 to 190.xx.xx.119 /29 and able to use from 113 to 118. Now we have 4 servers that we need to publish outside for our other branches. Our internal network use 172.16.11.0/24
So we just basically need to connect or NAT as follow: 172.16.11.2 Domain as 190.xx.xx.114
172.16.11.3 Productivity as 190.xx.xx.115
172.16.11.4 Development as 190.xx.xx.116
172.16.11.5 Security as 190.xx.xx.117
Understanding 113 should be nat outside and 172.16.11.254 should be nat inside We basically did the NAT commands and assigned the in and out addresses to the interfaces but nothing seems to happen, nobody from the other branches seems to reach any of the servers.
What's the true NAT science or exact commands procedure for this particular Public IP's assignment to servers?
I have made a copy of the #show run if needed here.
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...