cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
479
Views
0
Helpful
5
Replies
johnlloyd_13
Engager

PVDM64 Erased Router Config

hi all,

i've encountered my 2911 router config got wiped out after installing PVDM-64 DSP module and a VWIC3-2MFT-T1/E1.

when i did a sh inv and sh run i noticed the router hostname went back to Router and saved config gone.

is this related to the installed modules on this router (or i just forgot to save )?

5 REPLIES 5
Leo Laohoo
VIP Community Legend

Check the config register.

hi leo,

i don't think it's due to confreg.

it's 0x2102.

Cisco CISCO2911/K9 (revision 1.0) with 475136K/49152K bytes of memory.

Processor board ID xxx

3 Gigabit Ethernet interfaces

1 Serial(sync/async) interface

2 Channelized (E1 or T1)/PRI ports   <<< THESE IS WHAT I INSTALLED TODAY + PVDM64

4 Voice FXS interfaces 

DRAM configuration is 64 bits wide with parity enabled.  

255K bytes of non-volatile configuration memory.

250880K bytes of ATA System CompactFlash 0 (Read/Write)

License Info:

License UDI:

-------------------------------------------------

Device#   PID                   SN

-------------------------------------------------

*0        CISCO2911/K9         xxx

Technology Package License Information for Module:'c2900'

----------------------------------------------------------------

Technology    Technology-package          Technology-package

              Current       Type          Next reboot 

-----------------------------------------------------------------

ipbase        ipbasek9      Permanent     ipbasek9

security      None          None          None

uc            uck9          Permanent     uck9

data          None          None          None

Configuration register is 0x2102

nevermind, my colleague said it's blank coz it's a spare router

LOL.

That explains it. 

LOL ,nice one