03-02-2011 12:21 AM - edited 03-06-2019 03:50 PM
Hello mates,
We have Queuing printer model Q-MATIC TP3115 in one of our branches connected to Cisco 3560 Switch and its flapping so I did some changes on the switch port.
Below is the switch port configuration before change and after but still the printer is flapping , can anyone help with this matter if you work with the same issue before.
Switch port configuration before the change:
interface GigabitEthernet0/15
switchport access vlan 153
switchport mode access
switchport voice vlan 154
switchport port-security maximum 3
switchport port-security
switchport port-security violation protect
switchport port-security aging type inactivity
storm-control broadcast level 1.00
spanning-tree portfast
no spanning-tree bpduguard enable
end
Switch port configuration after the change:
interface GigabitEthernet0/15
description **** QMATIC PRINTER ****
switchport access vlan 153
switchport mode access
speed 10
duplex full
storm-control broadcast level 1.00
Here is show version of the switch :
Cisco IOS Software, C3560 Software (C3560-ADVIPSERVICESK9-M), Version 12.2(46)SE, RELEASE SOFTWARE (fc2)
Copyright (c) 1986-2008 by Cisco Systems, Inc.
Compiled Thu 21-Aug-08 15:26 by nachen
Image text-base: 0x00003000, data-base: 0x01A00000
ROM: Bootstrap program is C3560 boot loader
BOOTLDR: C3560 Boot Loader (C3560-HBOOT-M) Version 12.2(25r)SEE4, RELEASE SOFTWARE (fc1)
Switch uptime is 21 hours, 24 minutes
System returned to ROM by power-on
System image file is "flash:c3560-advipservicesk9-mz.122-46.SE.bin"
cisco WS-C3560G-24PS (PowerPC405) processor (revision H0) with 122880K/8184K bytes of memory.
Last reset from power-on
9 Virtual Ethernet interfaces
28 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 28 WS-C3560G-24PS 12.2(46)SE C3560-ADVIPSERVICESK9-M
Configuration register is 0xF
more over i check the printer online DOCs but there is nothing mentiond about what will be the SW port configuration.
http://www.datalex.gr/files/pdf/QMatic%20TP3115.pdf?phpMyAdmin=a44be1c193e15259a1643c233cb29f26
also when i connect it to a normal HUB its working fine.
Please Help
03-02-2011 08:21 AM
Have you tried all port speed/duplex combinations? What was the bub? 10 half?
Regards,
Ian
04-02-2011 01:33 AM
Actuallu i trird it also and its not working .
01-23-2014 12:11 AM
Hi ,
I hope that you are well . Have you found the root cause to this . I have a very similar issue .
Take care and I appreciate any assistance .
01-23-2014 02:30 PM
Hi,
actually vendor came and did some changes from thier end but from our side we kept our configuration as its
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide