cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
9593
Views
0
Helpful
7
Replies

Question about ASR 1002 and SFP-GE-T modules

eduardo.ramirez
Level 1
Level 1

Hi all I have asked two ASR 1002, but the true is that I never used / touch this boxes.

The idea is connect this two routers trough Metroethernet link but I am not sure if this interfaces with this Gbic modules  SFP-GE-T works 10/100/1000 or only works at 1000 like 4924 multilayer switches.

My current Metroethernet Link is just 10/100 FE

Somebody knows about that?

Thanks in advanced

1 Accepted Solution

Accepted Solutions

Hi Eduardo,

If it is 10/100/1000 then that is what it is.  it is not 10/100  10/100/1000 interface is copper not fiber

Reza

View solution in original post

7 Replies 7

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

That is Gig only.

HTH

Reza

Hi Reza thanks for your response.. .

I heard from other Engineer that 10/100/1000 built-in interfaces are only capable of 10/100 using the copper SFP..

did you know abou that  ?

Thanks

Hi Eduardo,

If it is 10/100/1000 then that is what it is.  it is not 10/100  10/100/1000 interface is copper not fiber

Reza

That is not true, the 1000Base-T SFP supports 10/100/1000. The problem is some modules only capable of 1GE like the WS-X6748-SFP.

http://www.cisco.com/en/US/prod/collateral/modules/ps5455/ps6577/product_data_sheet0900aecd8033f885.html

Regards,

jerry

Thanks for you help  Jerry

chris.rae07
Level 1
Level 1

Guys,

I am just deploying a pair of ASR 1006.

I am using the SPA-5X1GE-V2 with both GLC-T and SMF SFPs

cisco ASR1006 (RP1) processor with 709790K/6147K bytes of memory.
10 Gigabit Ethernet interfaces
32768K bytes of non-volatile configuration memory.
2097152K bytes of physical memory.
942079K bytes of eUSB flash at bootflash:.
39004543K bytes of SATA hard disk at harddisk:.

Configuration register is 0x2102

This is with Autonegotiation enabled

Router(config-if)#

Router(config)#int g0/0/0
Router(config-if)#speed ?
  10    Force 10 Mbps operation
  100   Force 100 Mbps operation
  1000  Force 1000 Mbps operation

Router(config-if)#speed 100
Auto-negotiation is enabled. Speed cannot be set

Turning off Autonegotiation

Router(config-if)#no negotiation auto

Router(config-if)#speed 100

Router(config-if)#speed 1000

Hope this helps

Chris

Hi  Chris it make sense to me ... 

I gona test....

Thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco