cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
969
Views
5
Helpful
3
Replies
Ahmed M Alzaeem
Beginner

question about #show ip arp in cisco 2960g switch !

hi ,  i would like to ask about  sh ip arp in cisco switch ,

if i type show ip arp in cisco switch , it only display the arp in vlan 1 , although i have alot of vlans conected to pcs and servers , but only it dispaly the arp of vlan 1 ,

on my switch  i have  an ip under interface vlan 1

how to display the app of all vlans ??

regards

1 ACCEPTED SOLUTION

Accepted Solutions
cadet alain
Advisor

Hi,

arp  request is sent on directly connected neighbours in the same vlan, for other vlan hosts you'll have  only arp entry for default-gateway.

Regards.

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.

View solution in original post

3 REPLIES 3
cadet alain
Advisor

Hi,

arp  request is sent on directly connected neighbours in the same vlan, for other vlan hosts you'll have  only arp entry for default-gateway.

Regards.

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.

View solution in original post

do u think putting an ip address on sw from each vlan will solve the issue ??

Hi,

in that case then if the devices are directly connected and on corresponding vlan then yes you'll see output in the arp cache after communicationg with them.

Regards.

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.