cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

453
Views
0
Helpful
1
Replies
Highlighted
Beginner

Question about Stacking

Hello there. 

 

I'm facing some issue with stacking practice with two ws_3850

 

                                             H/W   Current
Switch#   Role    Mac Address     Priority Version  State 
------------------------------------------------------------
*1       Active   3c5e.c353.9380     10     V04     Ready               
 2       Standby  547c.69df.a180     14     V04     Ready               
 9       Member   0000.0000.0000     0      0       Unprovisioned       <---- how to remove this from list???

 

I've tried

'no switch 9 provision'

'eload slot 9 
Switch 9 is not part of the stack'

 

 

Is there any way to fix this ?? and right step to remove stack member??

 

and.... how to switchover active role ? by reloading? any way by using command ?

 

What if there are five switches.

Five switches console ports always take me master(active) swich.  

how to figure out which switch is connected directly to my console cable?? 

 

 

Thank you : ) 

 

1 REPLY 1
VIP Expert

Hi,Is there any way to fix

Hi,

Is there any way to fix this ?? and right step to remove stack member??

The right way is to use the command you have already used (no switch 9 provision) and save the config

Since you are still seeing the switch, you may have to reload the stack.

and.... how to switchover active role ? by reloading? any way by using command ?

looking at your stack it appeaser that switch 2 has higher priority than the active switch. If you reboot the switch switch 2 should become the master since its priority is 14.

Rebooting cause downtime so make sure to do it during an outage

HTH

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards