03-08-2015 04:26 PM - edited 03-07-2019 11:00 PM
Hi,
I have been playing around with the "memory free low-watermark" command. However, the amount of free memory reported by this feature is not consistent with the output from the "show processes memory" command. See below.
switch#show proc mem
Processor Pool Total: 71050216 Used: 31824332 Free: 39225884
I/O Pool Total: 12582912 Used: 8673532 Free: 3909380
Driver te Pool Total: 1048576 Used: 40 Free: 1048536
switch#conf t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)#memory free low-watermark processor ?
<1-4294967295> low water mark of memory in KB
switch(config)#memory free low-watermark processor 10000
switch(config)#
000933: Mar 6 2015 10:40:32.486 nzdt: %SYS-4-FREEMEMLOW: Free Memory has dropped below low watermark
Pool: Processor Free: 5686000 Threshold: 10240000
switch(config)#end
switch#show ver
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 24 WS-C3750G-24T 12.2(55)SE9 C3750-IPBASEK9-M
2 24 WS-C3750G-24T 12.2(55)SE9 C3750-IPBASEK9-M
I also have the same behaviour on a WS-C2960S-24TS-L
Does anyone know why these memory free values are different?
03-15-2015 10:38 AM
Hi Tom,
Are you immediately seeing it after configuring it?
Or is it occassionaly reporting it?
Thanks,
M
03-15-2015 12:54 PM
Hi Madhukrishnan,
This occurs instantly after entering the command "memory free low-watermark processor 10000".
Thanks,
Tom
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: