cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
19002
Views
0
Helpful
3
Replies

"no shutdown" command is not working in 2970 switch port

Hamed Karimi
Level 1
Level 1

Hi Guys

a switch port is shutdown, but when i use NO SHUTDOWN command it is working and shows administratively down.

like this command does not affect on it. i should enable this port? what can i do

btw, port is not in errdisable and portfast is enabled.

3 Replies 3

Leo Laohoo
Hall of Fame
Hall of Fame

1.  Clear the logs;

2.  Un-shut the interface

3.  Wait for 5 seconds;

4.  Post the "sh logs".

4d17h: Gi0/5 can't be brought up because it failed POST in loopback test

Try #clear interface Gi0/5

Otherwise https://supportforums.cisco.com/thread/2153153

Best Regards

Please rate all helpful posts and close solved questions

Best Regards Please rate all helpful posts and close solved questions
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: