04-25-2013 09:23 AM - edited 03-07-2019 01:02 PM
Hello Community,
We have L3 switch that when I perform a "show run" it displays configured interfaces out of order or sequence. For example:
interface GigabitEthernet3/39
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 3000
switchport mode trunk
!
interface GigabitEthernet3/43
switchport
switchport access vlan 2000
!
interface GigabitEthernet3/1
switchport
switchport access vlan 2000
!
interface GigabitEthernet3/2
switchport
switchport access vlan 2000
!
interface GigabitEthernet3/3
switchport
switchport access vlan 2000
I have never seen this occur and it happens to newly configured interfaces. Is there something that I have done wrong? A bug in the IOS? Configured interfaces work fine, just out of order in the running config. Any insight would be great!
04-25-2013 09:37 AM
Try it again, if it's reproduceable then it's probably a bug though cosmetic it could be confusing if in a troubleshooting situation . Contact TAC it's an issue that's bothersome , though they will tell you to upgrade before you try anything else. Look for bugs in the bugtracker .
04-25-2013 09:46 AM
Hi,
Can you please post the output of "show version".
REgards
Inayath
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide