10-31-2013 08:08 AM - edited 03-07-2019 04:21 PM
I am having the same issue as listed in the following case:
https://supportforums.cisco.com/thread/161768
However- even when this is set as an access port- it is not doing rate limiting- should be rate limited to 2Mb (one port traffic goes in- one port traffic goes out- only 2 nodes on the switch). The relevant config is listed below:
class-map match-all HOC-CAM
match access-group 100
!
!
policy-map CAM-LIMIT
class HOC-CAM
police 2000000 32000 exceed-action drop
!
!
!
interface FastEthernet0/1
description Connection to HOC Camera
switchport mode access
load-interval 30
service-policy input CAM-LIMIT
!
!
interface FastEthernet0/24
description Uplink to HOC-1611Main-Catalyst
switchport mode dynamic desirable
service-policy input CAM-LIMIT
!
access-list 100 permit ip any any
Any suggestions?
Solved! Go to Solution.
10-31-2013 08:40 AM
Hi,
Your config looks OK to me but have you enable qos
!
mls qos
!
Regards,
Alex.
Please rate useful posts.
10-31-2013 08:40 AM
Hi,
Your config looks OK to me but have you enable qos
!
mls qos
!
Regards,
Alex.
Please rate useful posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide