I had no other choice but to do a factory reset on my 9300 series 48 port switch. I’m now posting to figure out my next steps.
The first thing I tried from the switch: prompt was to copy usbflash0:image bootflash: unfortunately after entering this command I get the error “write access to bootflash: unsupported”
The next thing I tired to do was from the switch: prompt flash_init but revived an error “command “flash_init” not found”
and finally from the switch: prompt I did a boot usbflash0:image. After the switch rebooted and into the image I tried to do a copy usbflash0 to bootflash that appeared to work and then a wr. But after rebooting found nothing “stuck”. And now I’m back at step one.
Any help I getting this switch up and running is gladly and happily appreciated.