cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
997
Views
0
Helpful
4
Replies

Reduced Bandwidth on Cisco 3550

I upgraded my cable connection to 200mbps. I have an ASA5506x with a 3550 switch. When I connect a PC or laptop direct to an ASA port I get full 200mbps. But when I connect to one of the ports on the 3550  speed gets reduced to only 100mbps. I tried changing the speed/duplex with no luck. Has anyone aver come across this?
Thx

4 Replies 4

Francesco Molino
VIP Alumni
VIP Alumni
Hi

Your 3550 switch is only 100mbps. You can't go higher than that speed.

Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question

I'll try a gig switch

Deepak Kumar
VIP Alumni
VIP Alumni

Cisco 3550 is having 100Mbps port only. This is a hardware limitation. Please upgrade your Switch with latest one, which can support 1Gbps. 

 

Regards,

Deepak Kumar

Regards,
Deepak Kumar,
Don't forget to vote and accept the solution if this comment will help you!

So basically there are various models for the Cisco 3550 that have specific hardware limitations. To verify which model you currently have you can run this command

Switch>show version
Cisco Internetwork Operating System Software
IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(22)EA13, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by cisco Systems, Inc.
Compiled Fri 27-Feb-09 22:20 by amvarma
Image text-base: 0x80010000, data-base: 0x80570000
ROM: Bootstrap program is C2950 boot loader
Switch uptime is 0 minutes
System returned to ROM by power-on
System image file is "flash:c2950-i6q4l2-mz.121-22.EA13.bin"
cisco WS-C2950-12 (RC32300) processor (revision B0) with 20957K bytes of memory.
Processor board ID FAB0535Q22L
Last reset from system-reset
Running Standard Image
12 FastEthernet/IEEE 802.3 interface(s)
32K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address: 00:06:D6:AB:A0:40
Motherboard assembly number: 73-5782-08
Motherboard serial number: FAB0535BC1K
Model revision number: B0
Model number: WS-C2950-12
System serial number: FAB0535Q22L
Configuration register is 0xF



After you find the model number compare it with the below versions, this can give you a better indication of what your device can handle.

Cisco Catalyst 3550-48

WS-C3550-48-EMI

●  48 10/100 ports and 2 GBIC-based Gigabit Ethernet ports
●  1 rack unit (RU) stackable, multilayer switch
●  Delivers enterprise-class intelligent services to the network edge
●  Enhanced Multilayer Software Image (EMI) installed
●  Provides advanced IP routing

Cisco Catalyst 3550-48

WS-C3550-48-SMI

●  48 10/100 ports and 2 GBIC-based Gigabit Ethernet ports
●  1 RU stackable, multilayer switch
●  Delivers enterprise-class intelligent services and basic IP routing to the network edge
●  Standard Multilayer Software Image (SMI) installed, upgradeable to advanced IP routing

Cisco Catalyst 3550-24

WS-C3550-24-EMI

●  24 10/100 ports and 2 GBIC-based Gigabit Ethernet ports
●  1 RU stackable, multilayer switch
●  Delivers enterprise-class intelligent services to the network edge
●  EMI installed
●  Provides advanced IP routing

Cisco Catalyst 3550-24

WS-C3550-24-SMI

●  24 10/100 ports and 2 GBIC-based Gigabit Ethernet ports
●  1 RU stackable, multilayer switch
●  Delivers enterprise-class intelligent services and basic IP routing to the network edge
●  SMI installed, upgradeable to advanced IP routing

Cisco Catalyst 3550-24 PWR

WS-C3550-24PWR-EMI

●  24 10/100 ports and 2 GBIC-based Gigabit Ethernet ports
●  1 RU stackable, multilayer switch; integrated inline power
●  Delivers enterprise-class intelligent services to the network edge
●  EMI installed
●  Provides advanced IP routing

Cisco Catalyst 3550-24 PWR

WS-C3550-24PWR-SMI

●  24 10/100 ports and 2 GBIC-based Gigabit Ethernet ports
●  1 RU stackable, multilayer switch; integrated inline power
●  Delivers enterprise-class intelligent services and basic IP routing to the network edge
●  SMI installed, upgradeable to advanced IP routing

Cisco Catalyst 3550-24 DC

WS-C3550-24-DC-SMI

●  24 10/100 ports and 2 GBIC-based Gigabit Ethernet ports
●  1 RU stackable, multilayer switch, DC powered
●  Delivers enterprise-class intelligent services and basic IP routing to the network edge
●  SMI installed, upgradeable to advanced IP routing

Cisco Catalyst 3550-24 FX

WS-C3550-24-FX-SMI

●  24 100FX multimode fiber ports and 2 GBIC-based Gigabit Ethernet ports
●  1 RU stackable, multilayer switch
●  Delivers enterprise-class intelligent services and basic IP routing to the network edge
●  SMI installed, upgradeable to advanced IP routing

Cisco Catalyst 3550-12G

WS-C3550-12G

●  10 GBIC-based Gigabit Ethernet ports and 2 10/100/1000 ports
●  1.5 RU stackable, multilayer Gigabit Ethernet switch
●  Delivers enterprise-class intelligent services to the network edge
●  Provides advanced IP routing

Cisco Catalyst 3550-12T

WS-C3550-12T

●  10 10/100/1000 ports and 2 GBIC-based Gigabit Ethernet ports
●  1.5 RU stackable, multilayer Gigabit Ethernet switch
●  Delivers enterprise-class intelligent services to the network edge
●  Provides advanced IP routing

EMI Upgrade Kit

CD-3550-EMI=

●  EMI upgrade kit for all standard versions of the Cisco Catalyst 3550-24, Catalyst 3550-24 PWR, Catalyst 3550-24 DC, Catalyst 3550-24 FX, and Catalyst 3550-48 Switches
●  Provides advanced IP routing


kind Regards
Jean-Pierre Roux

 

Review Cisco Networking products for a $25 gift card