cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
402
Views
0
Helpful
1
Replies

REP & Spanning Tree Issue

3 switches are connected in Ring and by default spanning tree block 1 port.. I have enable REP(RESILIENT ETHERNET PROTOCOL) as I execute command "rep segment 1" on each connected interface, it shows a message that ENABLING REP , disable spanning tree on particular port.. But as I check by  "show spanning-tree" command all the REP interface still showing in spanning tree..

 

 

 

Note : I have to disable STP, by enabling REP and Wants to connect switch to switch in Ring and wants port to come up instantly as I connect without going to LRN LSN FWD states .. Please help me in this...

1 ACCEPTED SOLUTION

Accepted Solutions
balaji.bandi
VIP Master

what is the device here, show us your config ? where it blocking ?

 

show rep topology

https://www.cisco.com/c/en/us/support/docs/lan-switching/ethernet/116384-technote-rep-00.html

 

BB

***** Rate All Helpful Responses *****

How to Ask The Community for Help

View solution in original post

1 REPLY 1
balaji.bandi
VIP Master

what is the device here, show us your config ? where it blocking ?

 

show rep topology

https://www.cisco.com/c/en/us/support/docs/lan-switching/ethernet/116384-technote-rep-00.html

 

BB

***** Rate All Helpful Responses *****

How to Ask The Community for Help

View solution in original post