10-18-2013 09:32 AM - edited 03-07-2019 04:06 PM
I'm planning to swapping our 8-port 10Gb (WS-X6708-10GE) to the 4-port 10Gb (WS-X6704-10GE).
Would this be the proper procedure?
If interface ten 1/1 on the 10-port card is my OSPF uplink, will this also remove my OSPF and VLAN settings?
Any help would be greatly appreciated!
Jason
Solved! Go to Solution.
10-18-2013 10:32 AM
Hello Jason.
It's as simple as swap the linecard, module clear-config command is not even a must. I guess when you say: If the interface ten 1/1 on the 10 port meaning the 8ports linecard, is my ospf uplink, if that's the only uplink your ospf neighbor will go down, but if there's a redundant connection it will stay up. Regarding vlan configuration, vlas are saved in the vlan database, they won't be erased.
Regards.
Wilson B.
Please rate useful post.
10-18-2013 10:32 AM
Hello Jason.
It's as simple as swap the linecard, module clear-config command is not even a must. I guess when you say: If the interface ten 1/1 on the 10 port meaning the 8ports linecard, is my ospf uplink, if that's the only uplink your ospf neighbor will go down, but if there's a redundant connection it will stay up. Regarding vlan configuration, vlas are saved in the vlan database, they won't be erased.
Regards.
Wilson B.
Please rate useful post.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide