Route-Map Config

[Rawa Salah]

HI All

i configured the route-map on router ,

r

oute-map Client_side_map permit 20

match ip address Client_side2

set ip next-hop xx.xx.xx.xx 

but when i enter show run  i see the following config thats marvel

!

route-map Client_side_map permit 20
match ip address Client_side2 Internet_side1
set ip next-hop xx.xx.xx.xx  xx.xx.xx.xx
!

any one can tell me what is the underline ?

[cadet alain]

Hi,

R4(config)#access-list 100 permit ip any any

R4(config)#access-list 101 permit ip any any

R4(config)#route-map test p 10

R4(config-route-map)#match ip add 100

R4(config-route-map)#set ip next

R4(config-route-map)#set ip next-hop 20.20.20.20

R4(config-route-map)#do sh route-map

route-map test, permit, sequence 10

  Match clauses:

    ip address (access-lists): 100

  Set clauses:

    ip next-hop 20.20.20.20

  Policy routing matches: 0 packets, 0 bytes

R4(config-route-map)#match ip add 101

R4(config-route-map)#set ip nex

R4(config-route-map)#set ip next-hop 22.22.22.22

R4(config-route-map)#do sh route-map

route-map test, permit, sequence 10

  Match clauses:

    ip address (access-lists): 100 101

  Set clauses:

    ip next-hop 20.20.20.20 22.22.22.22

  Policy routing matches: 0 packets, 0 bytes

As you see in this example multiple  same match or set statement are automatically rearranged in a OR fashion instead of  a AND fashion.

So I presume you already had a 20 clause in your route-map and so you edited it in the way I showed above.

Regards

Alain

Don't forget to rate helpful posts.