cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
783
Views
0
Helpful
4
Replies
Highlighted
Beginner

Router RIP

As we know by default, routers are configured to receive any version of rip (1 or 2) updates.

If we manually set the version (version 1 or version 2) via config, this changes to version 1 or 2 respectively.

Can anyone tell me how I can get the router to receive any version of rip again without clearing configs and starting again. In other words, is there a setting that lets me do that?

Thank you.

Everyone's tags (3)
3 ACCEPTED SOLUTIONS

Accepted Solutions
Highlighted
Hall of Fame Expert

Router RIP

If you want to go back to default, then just type "no version"

HTH

View solution in original post

Highlighted
Beginner

Router RIP

If you want to send/accept either RIP Version 1 or 2 packets.

Router(config) # int e0

Router(config-if) # ip rip receive version 1 2

Router(config-if )# ip rip send version 1 2

Regards, Sunil Khanna

View solution in original post

Highlighted
Advisor

Router RIP

Hi,

There is no global command to achieve what you want , the only global command concerning versions are:

-no version ---> default  send 1 receive any

-version 2 ---> send and receive 2

-version 1 ----> send and receive 1

If you want other combinations you'll have to use the interface commands proposed above.

Regards.

Alain.

Don't forget to rate helpful posts.

View solution in original post

4 REPLIES 4
Highlighted
Hall of Fame Expert

Router RIP

If you want to go back to default, then just type "no version"

HTH

View solution in original post

Highlighted
Beginner

Router RIP

If you want to send/accept either RIP Version 1 or 2 packets.

Router(config) # int e0

Router(config-if) # ip rip receive version 1 2

Router(config-if )# ip rip send version 1 2

Regards, Sunil Khanna

View solution in original post

Highlighted
Beginner

Router RIP

Thank you both for your replies.

What I was after was a command I could give without doing it for each interface i.e. globally. Reza's "no version" command works.

Now here's a challenge (well to me it is anyway).

Default is as we know:

Router#show ip protocols gives...

Default version control: send version 1, receive any version

Now If I do Router(config-router)#version 2 :

Router#show ip protocols gives...

Default version control: send version 2, receive version 2

As I have learnt from your replies by doing Router(config-router)#no version :

Router#show ip protocols goes back to...

Default version control: send version 1, receive any version

How about if I want router to send version 2 updates but receive any version, in other words how do I get

Router#show ip protocols to give me...

Default version control: send version 2, receive any version

again, instead of doing it individually per interface (of course I know I can use the range command, but that's not what I'm after) a global command to do this. I look forward to your replies.

Thanks again.

Highlighted
Advisor

Router RIP

Hi,

There is no global command to achieve what you want , the only global command concerning versions are:

-no version ---> default  send 1 receive any

-version 2 ---> send and receive 2

-version 1 ----> send and receive 1

If you want other combinations you'll have to use the interface commands proposed above.

Regards.

Alain.

Don't forget to rate helpful posts.

View solution in original post

Content for Community-Ad