Routing on the basis of Bandwidth utilization

[PRASAD BAIT]

Hi,

I have one Cisco 3745 router and have two ISPs. I have to do routing such that if one of the link gets utilised over 70% the traffic should be routed to the other ISP.

Regards,

Prasad Bait

[Mahesh Gohil]

Hello Prasad,

Optimized Edge Routing can fulfil your requirement

look at below link

http://www.cisco.com/en/US/docs/ios/oer/configuration/guide/oer-cfg_ap_polcy_ps6350_TSD_Products_Configuration_Guide_Chapter.html

Regards

Mahesh

[Steve Lyons]

Prasad,

OER or now known as PfR provides the capability to load share between two or more separate interfaces. This technology also has the capability to route based on application requirements (i.e.: throughput, delay, jitter, loss, MOS, reachability) I would recommend the following document for review:

http://www.cisco.com/en/US/partner/docs/solutions/Enterprise/WAN_and_MAN/Transport_diversity/Transport_Diversity_PfR.html

If you have further questions let me know.

Best Regards,

Steve Lyons - Cisco