cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
4994
Views
0
Helpful
3
Replies
manju.cisco
Participant

RPS Status on WS-C3750G-48PS-E

Hi All,

We recently connected a RPS 2300 to our switch WS-C3750G-48PS-E with IOS c3750-ipservicesk9-mz.122-53.SE2.bin.

.

However i do not see any RPS details in the"show env" output.

I believe i should get the RPS Name and its Serial and the port number in the output, but i am not finding it in the output. I did reload the switch but still couldnot get this udpated.

Why is this so ?? Is there any alternate command that helps to see this ??

Importantly i now doubt the Switch w.r.t RPS is functioning properly or not........Any advise is greatly appreciated. Thank you.

PS: Power failover test will be carried later when we have a schedule. So till now we have just connected the RPS to the Switch.

----------------------------------------------------

#show env all

FAN is OK

TEMPERATURE is OK

Temperature Value: 47 Degree Celsius

Temperature State: GREEN

Yellow Threshold : 58 Degree Celsius

Red Threshold    : 68 Degree Celsius

SW  PID                 Serial#     Status           Sys Pwr  PoE Pwr  Watts

--  ------------------  ----------  ---------------  -------  -------  -----

1  Built-in                                         Good

SW  Status          RPS Name          RPS Serial#  RPS Port#

--  -------------   ----------------  -----------  ---------

1   Active          <>

--------------------------------------------------------------

Thank you,

Manjunath

3 REPLIES 3
Richard Michael
Cisco Employee

Hello Manju,

You are not able to see the RPS details because of a cosmetic bug CSCee96721. During the failover testing everything should work properly. Let me know how the test goes.

Thanks,

Ricky Micky

*Rate useful posts

Reza Sharifi
Hall of Fame Expert

Hi Manjunath,

It appears that there is something wrong with the output of "sh env al"l from your switch.

Have a look at this one from a 3750-E

Switch#sh env all

FAN is OK

TEMPERATURE is OK

Temperature Value: 33 Degree Celsius

Temperature State: GREEN

Yellow Threshold : 49 Degree Celsius

Red Threshold    : 59 Degree Celsius

SW  PID                 Serial#     Status           Sys Pwr  PoE Pwr  Watts

--  ------------------  ----------  ---------------  -------  -------  -----

1  C3K-PWR-750WAC      SSS1E50MSSA  OK              Good     Good     300/420

SW  Status          RPS Name          RPS Serial#  RPS Port#

--  -------------   ----------------  -----------  ---------

1   <>              <>

Switch#sh ver | inc ver

System image file is "flash:/c3750e-universal-mz.122-52.SE/c3750e-universal-mz.122-52.SE.bin"

The password-recovery mechanism is enabled.

Switch#

But your's does not show the PID for the power supply, the S/N and the Wattage, but it does show that you have an Active RPS.

HTH

smogra
Cisco Employee

I would recommend to disconnect and connect the RPS again. Make sure that you remove the cables and plug them back in properly. This should help.

--Sweta