Dear guys,
I have 3 Catalyst 2960S-24PS-L in a stack, which are Power back-upped by a RPS 2300 Unit. I needed to replace the APC and therefore i need to switch the internal power of the switches to the new APC. I've done this for 2 of the switches in stack already and the RPS2300 did do his job. However I now connected the switches back on the new APC and the Switches remain on RPS.
I read about a needed reload since i don't have an e-serie switch.
I have scheduled the reload this weekend but the switches still remain on the RPS.
RPS Led on the switches blinking amber for these 2 switches, the 3th switch is blinking green but that's expected behavior since the RPS is already providing power to the other 2 switches.
DC output on the RPS switches:
the leds of the 2 switches are blinking green, and 1 static amber (expected behavior)
So my question how to get the switches on the internal power again? Since the reload didn't fixed it?
Thanks in advance
