Hi,
I have RSPAN configuration, but I see only broadcast/multicast traffic.
I have this:
PC (vlan 100) - SW1 -(trunk)- SW2 -(trunk)- SW3 -(trunk)- SW4 - (gi0/23) tcpdump
SW1 - 2960 - c2960-lanbasek9-mz.122-50.SE5
SW2 - 2960
SW3 - 3750X
SW4 - 2960
All switches are VTP domain members. VTP pruning mode is enabled.
VLAN 997 is remote span vlan.
The command "sh vlan remote-span" on all switces output is below:
Remote SPAN VLANs
------------------------------------------------------------------------------
997
Config SW1:
monitor session 1 source vlan 100
monitor session 1 destination remote vlan 997
Config SW4:
monitor session 1 destination interface Gi0/23
monitor session 1 source remote vlan 997
sh run int gi0/23
interface GigabitEthernet0/23
switchport mode access
end
Linux endpoint have a eth1 interface in promisc mode:
netstat -i
eth1 BMPRU
Where I can be wrong in the configuration?
Thanks.