12-30-2020 05:14 AM
Hello,
I'm trying to configure selective qinq on my 3850 switch on ios 16.6.8 but I don't know how to proceed. For example, only customer vlans 100 and 200 will have a svlan 500. All other traffic will not be tagged with id 500.
Could someone help me please ?
Thanks in advance
Solved! Go to Solution.
12-30-2020 06:34 AM - edited 12-30-2020 06:36 AM
check in the feature navigator :
12-30-2020 05:35 AM
Not sure how your network connected - do you have any network topology to understand better.
or you an refer below blog to start with :
12-30-2020 06:09 AM
hanks for the link !
Actually, It's a new switch with no config on it yet. I just wanted to ensure that the firmware version supports selective Q-in-Q mapping.
The planned topology is to configure one interface on trunk mode with vlan 610 and 101, and on another interface configure dot1q-tunnel mode like below:
interface gigabiethernet0/1
switchport vlan mapping 1 101
switchport vlan mapping 2 610
But these commands are not available on 3850 with 16.6.8 ios version
12-30-2020 06:34 AM - edited 12-30-2020 06:36 AM
check in the feature navigator :
12-30-2020 07:42 AM
Thanks !
It helps a lot
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide